How is the enamel reactor heat transfer

Enamel reactor as chemical machinery and equipment, its internal raw materials are sometimes chemical reactions, and chemical reactions are carried out in the heating, which stipulates that the reactor machinery and equipment can not only give a good reflection of the site, but also need to have a certain heat exchange effect.

Compared with the vertical, enamel reactor DIH is relatively large, sometimes, simple with the common kettle outside the jacket heat transfer area is limited, and the larger the diameter of the kettle, the enterprise kettle volume heat transfer area must be smaller, and reflect the raw materials are continuously improving, at this time, it will be difficult to increase the work. In other words, from the perspective of heat transfer area, increasing utility is not negligible. Therefore, industrial production on the selection of the following countermeasures, in order to fill its insufficient:

(1) In addition to the collet clamp, spiral steel pipe can also be set in the reactor;

(2) The basis of heat transfer outside the kettle is different. Another pump can be added in the kettle to make the liquid circulating heat transfer outside the kettle; When there is a low melting point of organic solvent in the whole process of reflection (such as polycondensation), a cooler should be added outside the kettle to flow back the organic solvent and manipulate a certain reflecting temperature.